Forum archiveWorkshop Manual
This is a read-only archive of the ST70.net forum (2009–2021). Posting, accounts and private messages are no longer available.

Axle Bolts

Started by James · 4 replies · 2821 views

JamesModeratorPosts: 423
Joined: Feb 2009
Anyone know where I can get Axle Bolts from? I need both the front and rear bolts.

CMS and David Silver Spares have sold out and apparently Honda have discontinued them! :(

Thanks
JamesModeratorPosts: 423
Joined: Feb 2009
I have emailed CMSNL this morning in the hope they can tell me when they will get them back in stock.

These are pretty much the only two parts I need to order which aren't in stock! I can't re-use them as they are in bad shape (rusted pretty badly).

Fingers crossed they will be able to get them otherwise I will have to order some from America (which aren't the proper Honda part). :(
JamesModeratorPosts: 423
Joined: Feb 2009
Just had a reply:
Dear James,

These parts are discontinued so they won't be made anymore.
You could however put these parts in a wishlist because if we succeed to find the parts our system automatically send you an email that the part is available again.
This could happen in a week, a month, a year, 2 years or it could never happen. I can't tell you.
I'm very sorry for the inconvenience.

Kind regards,
Christine Hensen
CMS
So looks like I won't be able to buy them. Either I try and clean up the old ones or get the ones from America.
WaynusModeratorPosts: 1108
Joined: Feb 2009
hmmm...
I'd try to get yours as good as new.

The other solutions are going to cost you, I'm afraid.
However, you should be able to find them used, but as good as new.
JamesModeratorPosts: 423
Joined: Feb 2009
Waynus wrote:hmmm...
I'd try to get yours as good as new.

The other solutions are going to cost you, I'm afraid.
However, you should be able to find them used, but as good as new.
Mine are pretty badly rusted and I used one of them to bash the bearings out :lol:

Might just have to bite the bullet and order those ones from DRATV in the States.

‹ Back to Technical