Settings

Hi everyone I am going to rebuild a 6v St70 engine and require the following settings : Points gap, Plug gap and the make and spec , Tappet clearence ,Std Carb settings , Grade of Oil ,Torque settings and anything else that anyone can think of , I will keep you all informed how the rebuild goes and if I have time take pictures as I go along but I can`t promise

Sounds like you need a manual?

spark plug gap = 0.6 - 0.7 mm
NGK C7HSA

Points gap = 0.3mm - 0.4mm
They should open right before 'F'
I strongly suggest to check timing with a stroboscope.

Tappet clearance
0.05mm on warm engine

Carb settings:
trial and error

Oil: Any 10w40 for wet clutches will do fine

Torque settings: refer to workshop manual

Blue wrote:Sounds like you need a manual?

I do I have sent you a message with my email address

Check your inbox

Waynus wrote:
Tappet clearance
0.05mm on warm engine

Waynus, should it not be on a cold engine? I think it says so in the drivers manual?

Thanks Blue
I have got the manual

White wrote:Waynus, should it not be on a cold engine? I think it says so in the drivers manual?

Yeah,
every manual says 'cold'.
Every technician says 'warm'.

Just go with the method you're most comfortable with.
It's a long discussion

http://www.rooney.org/tlc/CT/CT70%20Man ... nual_2.pdf

maybe it's a good help for all club members